Banana Pi BPI-F3
RISC-V single-board computer with the SpacemiT K1 octa-core chip.
hardware
also known as BPI-F3, Banana Pi F3
Knowledge about Banana Pi BPI-F3
- Armbian on Banana Pi: BPI-M5, M7, M4 Zero, M2S and F3 have 'Standard support', BPI-R4 only 'Community support'recommendation · unverified · Before choosing Banana Pi's own images, check the board on armbian.com. At the time of writing, the BPI-M5, BPI-M7, BPI-M4 Zero, BPI-M2S and BPI-F3 pages show Standard support, the BPI-R4 page Community support. Vendor images can be old: the BPI-M5's newest Ubuntu image on its docs page is Ubuntu 20.04 from 2023.
- Banana Pi BPI-F3: a RISC-V SBC with the SpacemiT K1, and which operating systems it runsguide · unverified · The BPI-F3 uses the SpacemiT K1, an octa-core 64-bit RISC-V chip with 2.0 TOPS of AI compute. Banana Pi's docs list Bianbu Linux (SpacemiT), an OpenWrt 23.05.2 source tree, Armbian and an ArchLinux port; Armbian shows it with Standard support. It has a 26-pin header and a -40 to 85 °C operating range.
- Banana Pi lineup decoded: M boards, R router boards, F RISC-V boards, and which SoC is insideguide · unverified · Banana Pi sells many boards built on chips from different vendors. Group them by SoC: MediaTek Filogic router boards (BPI-R), Allwinner and Amlogic boards (BPI-M, P2 Zero), and RISC-V SpacemiT K1 boards (BPI-F3, CM6). Software support follows the SoC, not the brand.
- Banana Pi power supplies: 5 V over USB for the M boards, 12 V or 19 V barrel jacks for the router boardswarning · unverified · Banana Pi boards don't share one power standard. The BPI-M5 and BPI-M4 Zero take 5 V / 3 A over USB, the BPI-R3 needs 12 V / 2 A, the BPI-R4 12 V / 5.2 A or 19 V / 3.2 A, and the BPI-R3 Mini 12 V (20 W) or USB-C PD. Check each board's page before reusing a supply.
- GPIO on Banana Pi: the RPi.GPIO and WiringPi ports only do simple I/O, and BCM numbers are translatedwarning · unverified · Banana Pi's docs point to ports of WiringPi (with gpio readall) and RPi.GPIO for boards like the BPI-M5, M2S, M4 Zero and F3. The RPi.GPIO port states that only simple I/O works — PWM, events and analog read are not implemented — apps need root, and BCM numbers are mapped to Banana Pi pins internally.